Commissioning

Commissioning

Your B&G or Simrad navigation equipment properly set up and calibrated.

⏱

Duration

On average 3 hours, excluding travel time.

👥

Participants

Maximum 2 people at a time.

⚓

Location

On board in the harbour, plus a short sea trial on open water.

In advance you receive a questionnaire from us in which you state which B&G or Simrad equipment you have on board. That way I know exactly what can or must be commissioned. It is very important that you update the software of your equipment to the latest version beforehand; that saves a lot of time. You also need a current and compatible Navionics or C-MAP chart in your chartplotter.

The most common sensors are: depth, speed, water temperature, GPS, wind sensor, digital compass and rudder angle sensor.

Beyond that, it usually involves one or more instruments, such as the Triton², Nemesis or IS4x series, and one or more chartplotters, such as the B&G Vulcan or Zeus 2/3/S and SR series. For Simrad these are the GO, NSX, NSS or NSO series. Of course the autopilot and the radar are set up as well.

We start with all basic settings and the calibrations that are done while stationary. Then we calibrate the compass, the log and the wind sensor while underway. Next we set up the autopilot and finally the radar. Throughout the process I explain how and why we do things. After this training you can do it yourself.

Afterwards you receive an overview of all settings and calibration values. We also store these digitally and you get a copy to take with you.

Disclaimer: this is not a commissioning according to B&G or Simrad certification. For that, please contact a certified B&G or Simrad dealer (Technical Dealer).

Would you like to take this training?

Request a quote without obligation.